G-PYS9NQ48Y1

QD-SHR315

$19.95
(0) Write a Review
SKU:
Light Rite head and tail restoration kit.
Condition:
New
Availability:
Ships Same Day (3pm)
Weight:
2.00 LBS
Shipping:
Calculated at Checkout

Product Description

Qwiklens Headlight & Taillight Restorer

Description

Restores Headlights and Taillights to the brand new show room shine. For best results, perform headlight restoration process in a clean, dust free area and avoid direct sunlight and Wear the included glove.Your headlight restoration kit provides you with a "like new" headlight at a fraction of the cost of replacement.

Contents

  • #1 Kwikprep Solution
  • #2 Kwikclean Solution
  • #3 Kwikseal Solution
  • 1 Aplicator Cap with spout
  • 2 Heavy Duty Shop Towels
  • 1 Foam Brush for Application
  • 1 Glove
  • 1 Sheet of RED DOT Sandpaper
  • 1 Sheet of GREEN DOT Sandpaper
  • 1 Sheet of YELLOW DOT Sandpaper

Features

  • Easy as 1,2,3
  • Only takes 15 minutes per set

Dimensions

  • Weight : .68 lbs
  • Height : 1 1/2"
  • Width : 3 1/2"
  • Depth : 5"

Directions

Step 1 : Clean and prep headlights

Step 2: Apply a generous amount of #1 Kwikprep to the lens. Then, using RED DOT sandpaper supplied in kit, vigorously sand oxidized areas of lens, keeping the sanding surface wet with #1 Kwikprep. Continue sanding for approximately 2-3 minutes until smooth to the touch.

Step 3: Continue sanding and polishing process with the YELLOW DOT sandpaper. Keep work area wet with #1 Kwikprep. Continue sanding for approx. 2-3 minutes. This removes large sand marks from red dot sandpaper. When finished, wipe lens with towel removing grit residue.

Step 4: Apply #1 Kwikprep and continue sanding, polishing process with GREEN DOT sandpaper. Sand for approx. 1-2minutes

Step 5: Wipe clean with towel until lens is dry, free of dirt, grime or dust

Step 6: Pour #2 Kwikclean on towel and clean lens. This is a preview of finished product. If happy with lens, move to step 7. If not satisfied with lens appearance, then repeat sanding, polishing steps.

Step 7: To seal the lens, apply #3 Kwikseal to foam brush applicator. Move right to left, starting at top of headlight. Continue process to bottom of lens. Smooth any lines, streaks or uneven areas to achieve smooth finish. Be careful not to over brush as this may cause streaks. When #3 Kwikseal dries, the process is complete. DO NOT WASH CAR for 24 hours while sealant cures.

Videos